Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.7 - Page 1364

Example console(config-router-af)#neighbor 10.130.14.55 send-community neighbor shutdown Use the neighbor shutdown command to administratively disable communications with a specific BGP neighbor. The effect is to gracefully bring down the adjacency with the neighbor. If the adjacency is up when the command is given, the peering session is dropped and all route information learned from the neighbor is purged. Syntax neighbor { ip-address | ipv6-address [interface interface-id] | autodetect interface interface-id } shutdown no neighbor { ip-address | ipv6-address [interface interface-id] | autodetect interface interface-id } shutdown • ip-address - The neighbor's IPv4 address. This is the IP address of the neighbor on the connected link. • ipv6-address- The neighbor's IPv6 address. If the neighbor's IPv6 address is a link local address, the local interface must also be specified. Valid in IPv6 address family configuration mode. • interface-id - The local VLAN routing interface over which the IPv6 neighbor can be reached. Use the vlan keyword and a VLAN ID. Range 14093. • autodetect interface interface-id-(Optional) The routing interface on which the neighbor's link local IPv6 address is auto detected. The interface-id must be a VLAN routing interface. Range is 1-4093. Default Configuration Neighbors are administratively enabled by default. Command Mode BGP Router Configuration, IPv4 Address Family Configuration, IPv6 Address Family Configuration Layer 3 Routing Commands 1364