Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.7 - Page 1118

Example The following command sets the number of seconds that the switch waits for a response to an EAP-request/identity frame to 60 seconds. A side effect of this setting is that a MAB device might take several minutes to be authenticated. console(config)# interface gigabitethernet 1/0/16 console(config-if-Gi1/0/16)# dot1x timeout tx-period 60 The following example sets the time for the retransmission to the authentication server to 90 seconds. A side effect of this setting is that an authentication over an unreliable link to the authentication server might take as long as six or seven minutes. console(config-if-gi1/0/1)# dot1x timeout server-timeout 90 authentication timer reauthenticate Use the authentication timer reauthenticate command in Interface Configuration mode to set the number of seconds between reauthentication attempts. To return to the default setting, use the no form of this command. Syntax authentication timer reauthenticate {seconds|server} no authentication timer reauthenticate • seconds - Number of seconds between re-authentication attempts. (Range: 300-4294967295) • server- Utilize the Session-Timeout (RADIUS attribute 27) value received from the RADIUS server. Default Configuration The default re-authentication period is 3600 seconds. By default, the switch will utilize the value sent by the authentication server, if any. Command Mode Interface Configuration (Ethernet) mode Security Commands 1118