Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.7 - Page 2007

When copying files to or from a USB stick, do not remove the USB stick during file transfer. Use the unmount command to cleanly detach the USB stick before physical removal. After running the unmount command, the USB stick must be physically removed and re-inserted before accessing again. An ONIE firmware image may be copied onto the management unit in the stack using the onie-fw-update destination URL. ONIE firmware updates are distributed to the stack member automatically and are executed on stack reboot. The management unit in the stack requires at least 10 minutes after the image has been copied on to the primary to distribute the images across the stack. Examples Example - Backing up the running-config console#copy running-config backup-config This operation may take a few minutes. Management interfaces will not be available during this time. Are you sure you want to save? (y/n) y Configuration saved! Example - Downloading new code to the switch console#copy tftp://10.27.9.99/jmclendo/N3000-ONv6.0.1.3.stk backup Transfer Mode TFTP Server IP Address 10.27.9.99 Source File Path jmclendo/ Source Filename N3000-ONv6.0.1.3.stk Data Type Code Destination Filename backup Management access will be blocked for the duration of the transfer Are you sure you want to start? (y/n) y File transfer in progress. Management access will be blocked for the duration of the transfer. please wait... TFTP Code transfer starting... 17128797 bytes transferred... File contents are valid. Copying file to flash... Switch Management Commands 2007