Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.7 - Page 1376

• match-(Optional) By default, if BGP is configured to redistribute OSPF routes (redistribute ospf command), BGP only redistributes internal routes (OSPF intra-area and inter-area routes). Use of the match option configures BGP to also redistribute specific types of external or internal routes, or to disable redistribution of OSPF routes. The match option is only valid for OSPF originated routes. Successive redistribute commands are additive. Use the no form of the command to disable redistribution of a route source. • route-map map-tag-(Optional) A route map can be used to filter redistributed routes by destination prefix using a prefix list. Default Configuration BGP redistributes no routes by default. When BGP redistributes OSPF routes, it redistributes only internal routes unless the match option specifies external routes. Command Mode IPv6 Address Family Configuration mode User Guidelines The distribute-list out command can also be used to filter redistributed routes by prefix. Either a redistribute route map or a distribute list may be configured, but not both. Successive invocations of the redistribute command are additive. The redistribute command does not overwrite previous redistribute command configuration or the default configuration. Use the no redistribute command to remove the redistribution of internal or external routes. A default route cannot be redistributed unless the default-informationoriginate command is given. The configured metric value is specific to the routes distributed. Use the default-metric command to configure a default metric for all redistributed routes. In IPv6 address family configuration mode, the syntax and behavior is the same as for IPv4, except that Dell EMC Networking does not support RIP for IPv6. In conformance with RFC 1475, information learned via BGP from peers within the same AS is not redistributed to OSPF. Layer 3 Routing Commands 1376