Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.7 - Page 1299

BGP is enabled by default once the administrator has specified the local AS number with the router bgp command and configured a router ID with the bgp router-id command. BGP is not operable until a BGP router ID has been assigned. The BGP administrative state (as set by the enable command) has no operational effect until a router id is assigned to the BGP router. Command History Introduced in version 6.2.0.1 firmware. Example console(config-router)#bgp router-id 10.27.21.142 clear ip bgp Use the clear ip bgp command to reset peering sessions with all of a subnet of BGP peers. The command arguments specify which peering sessions are reset and the type of reset performed. Syntax clear ip bgp [vrf vrf-name]{* | as-number | ipv4-address | ipv6-address [ interface interface-id ] {listen range network/length}} [soft [in | out]] • vrf-name-This optional parameter identifies the VRF for which to reset peering sessions. If not given, the default sessions are reset. • *- Reset adjacency with every BGP peer. • as-number- Only reset adjacencies with BGP peers in the given autonomous system. The router's autonomous system number in asplain format. Dell EMC Networking BGP supports four byte AS numbers, in the range of 0-429496729. • ipv4-address-Only reset the adjacency with a single specified peer with a given IPv4 peer address. • ipv6-address [ interface interface-id ]-Only reset the adjacency with a single specified peer with a given IPv6 peer address. If the interface-id is given, only reset the adjacency on the specified interface. The interface id must be a routing interface (a routed VLAN identifier). An adjacency that is formed with the auto-detect feature cannot be reset with the command. Layer 3 Routing Commands 1299