Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.7 - Page 906

appear in the frame. Due to the internal processing of QinQ tagging, the TPID of ingress frames mirrored from the SP port will always be 0x8100. In addition, packets forwarded internally across a stacking link may have different tags applied than packets forwarded on a local egress port. This is due to the processing required for forwarding across a stack. Example This example configures ports Gi1/0/10 through Gi1/0/24 as CE ports using VLAN 10 as the service provider VLAN ID. See the example for the switchport dot1q ethertype command to configure an associated SP port. console(config)#vlan 10 console(config-vlan10)#exit console(config)#interface range gi1/0/10-24 console(config-if)#switchport access vlan 10 console(config-if)#switchport mode dot1q-tunnel console(config-if)#exit switchport mode private-vlan Use the switchport mode private-vlan command in Interface Configuration mode to define a private VLAN association for an isolated or community interface or a mapping for a promiscuous interface. Use the no form of the command to remove the private VLAN association or mapping from the interface. Syntax switchport mode private-vlan {host|promiscuous | trunk promiscuous | trunk secondary} no switchport mode private-vlan • host-Configure the interface as a private VLAN host port. Host ports are community or isolated ports, depending on the VLAN to which they belong. • promiscuous-Configure the interface as a private VLAN promiscuous port. Promiscuous ports are members of the primary VLAN. • trunk promiscuous-Configures an interface as a private VLAN promiscuous trunk port. These ports can carry traffic of several primary VLANs and normal VLANs. Layer 2 Switching Commands 906