Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.7 - Page 2270

The filter name may include any printable characters except a question mark. Enclose the string in double quotes to include spaces within the name. The surrounding quotes are not used as part of the name. The CLI does not filter illegal characters and may accept entries up to the first illegal character or reject the entry entirely. Per RFC 2573, configuring a filter adds an implicit exclude-all as the first entry in a filter record. Unless an include statement is specified, all notifications are excluded by default. Examples The following example creates a filter that includes all objects in the MIB-II system group except for sysServices (System 7) and all objects for interface 1 in the MIB-II interfaces group. console(config)# snmp-server filter user-filter system included console(config)# snmp-server filter user-filter system.7 excluded console(config)# snmp-server filter user-filter ifEntry.*.1 included snmp-server group Use the snmp-server group command in Global Configuration mode to configure a new Simple Management Protocol (SNMP) group or a table that maps SNMP users to SNMP views. To remove a specified SNMP group, use the no form of this command. Syntax snmp-server group groupname { v1 | v2 | v3 { noauth | auth | priv } [ notify notifyview ] } [ context contextname ] [ read readview ] [ write writeview ] no snmp-server group groupname { v1 | v2 | v3 { noauth | auth | priv } } [ context contextname ] • groupname - Specifies the name of the group. (Range: 1-30 characters.) • v1 - Indicates the SNMP Version 1 security model. • v2 - Indicates the SNMP Version 2 security model. • v3 - Indicates the SNMP Version 3 security model. • noauth - Indicates no authentication of a packet. Applicable only to the SNMP Version 3 security model. Switch Management Commands 2270