Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.7 - Page 242

Loopback Interfaces Loopback interfaces are represented in the CLI by the keyword loopback followed by the variable loopback-id, which can assume values from 0-7. Port Channel Interfaces Port-channel (or LAG) interfaces are represented in the CLI by the keyword port-channel followed by the variable port-channel-number. When listed in command line output, port channel interfaces are preceded by the characters Po. Tunnel Interfaces Tunnel interfaces are represented in the CLI by the keyword tunnel followed by the variable tunnel-id, which can assume values from 0-7. VLAN Routing Interfaces VLAN interfaces are represented in the CLI by the keywords interface vlan followed by the variable vlan-id, which can can assume values from 1-4093. A VLAN routing interface will typically have an IP address assigned, either via DHCP or a static assignment or, in the case of IPv6, auto assignment of a link local address. Operating on Multiple Interfaces (Ranges) The CLI allows the user to operate on multiple interfaces in one operation. The guidelines are as follows for range operation: • The range key word is used to identify that an interface range specifier follows. - An interface range specifier consists of an interface identifier followed by an optional range parameter. The interface type may be an Ethernet interface or a logical interface (port channel or VLAN) as described in the Interface Naming Conventions section. • The range parameter may be written in the following manner: (#-#) - a range from a particular interface to another higher-numbered interface (inclusive). For example, 1/0/1-10 indicates that the operation applies to the Ethernet interfaces 1 to 10 in slot 0 on unit 1. The number Using the CLI 242