Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.7 - Page 2404

Syntax stack-port interface-id shutdown no stack-port interface-id shutdown • interface-id-The stacking interface identifier. Default Configuration There no default configuration for this command. Command Modes Stack Configuration mode User Guidelines This command must be used with caution, as disabling a stack port causes the stack to attempt to reconverge. Ensure that the stack is in an active ring topology in order to avoid a stack split. Check the stack ports for errors and also verify that NSF is synced before shutting down any stacking links. Application messages will appear in the logs during stack convergence. This command persists across reboots, therefore, administrators should use this command with caution during stack upgrade procedures. Example console(config-stack)#stack-port tengigabitethernet 1/2/1 shutdown Disabling a stack port will cause the stack to attempt to re-converge. Application messages will appear in the logs during stack convergence. Before shutting down a stack link, please ensure that your stack is in an active ring topology in order to avoid a stack split. Continue? (y/n) console(config-stack)#no stack-port twentygigbitethernet 1/0/1 shutdown standby Use the standby command to configure the standby unit in the stack. This unit comes up as the primary when the stack failover occurs. Use the no form of this command to reset to default, in which case, a standby is automatically selected from the existing stack units if there no preconfiguration. Switch Management Commands 2404