Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.7 - Page 576

• fragments-Specifies the rule matches packets that are non-initial fragments (fragment bit asserted). Not valid for rules that match L4 information such as TCP port number since that information is carried in the initial packet. IPv6 fragments contain an IPv6 Fragment extension header. • routing-Specifies that IP ACL rule matches on routed packets. Routed packets contain an IPv6 "routing" extension header. • log-Specifies that this rule is to be logged when the rule has been matched one or more times since the expiry of the last logging interval. The logging interval is five minutes. • time-range time-range-name-Allows imposing time limitation on the ACL rule as defined by the parameter time-range-name. If a time range with the specified name does not exist and the ACL containing this ACL rule is applied to an interface or bound to a VLAN, then the ACL rule is applied immediately. If a time range with specified name exists and the ACL containing this ACL rule is applied to an interface or bound to a VLAN, then the ACL rule is applied when the time-range with specified name becomes active. The ACL rule is removed when the time-range with specified name becomes inactive. • assign-queue queue-id-Specifies the assign-queue, which is the queue identifier to which packets matching this rule are assigned. • {mirror | redirect} interface-id-Specifies the mirror or redirect Ethernet interface to which packets matching this rule are copied or forwarded, respectively. The mirroring or redirect logic stage occurs after the tag processing stage on ingress. Egress mirroring or redirect is not supported. • rate-limit rate burst-size-Specifies the allowed rate of traffic as per the configured rate in Kbps, and burst-size in kbytes. - Rate - the committed rate in kilobits per second - Burst-size - the committed burst size in Kilobytes. Default Configuration An implicit deny all condition is added by the system after the last MAC or IP/IPv6 access group if no route-map is configured on the interface. Layer 2 Switching Commands 576