Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.7 - Page 1416

User Guidelines Since IPv4 prefixes can only be exchanged over IPv4 peering, the neighboraddress parameter must be an IPv4 peer address. This option limits the output to show a single neighbor. If no neighbor address is specified, the command shows all neighbors enabled for IPv4 prefix exchange. If the vrf-name argument is specified, information pertaining to that VRF is displayed. The following fields are displayed. Field Description Remote Address The neighbor's IP address Remote AS The neighbor's autonomous system number Peer ID The neighbor's BGP router ID Peer Admin Status START or STOP Peer State The adjacency state of this neighbor Local Port TCP port number on the local end of the connection Remote Port TCP port number on the remote end of the connection Connection Retry Interval How long BGP waits between connection retries Neighbor Capabilities Optional capabilities reported by the neighbor, recognized and accepted by this router. Codes listed in the show output are as follows: • MP: Multiprotocol • RF: Route Refresh This version of Dell EMC Networking does not support any multiprotocol AFI/SAFI pairs other than IPv4 unicast. The presence of this capability does not imply otherwise. Next Hop Self If the local router is configured to advertise one of its own IP addresses as the BGP Next Hop when advertising a path learned from an external peer. Update Source The configured value for the source IP address of packets sent to this peer. This field is only included in the output if the update source is configured. Layer 3 Routing Commands 1416