Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.7 - Page 1204

passwords strength minimum lowercase-letters passwords strength minimum special-characters passwords strength minimum numeric-characters passwords strength max-limit consecutive-characters passwords strength max-limit repeated-characters passwords strength minimum character-classes Minimum strength validation validates a password containing a character in the corresponding character class. If a character class is configured with a strength check minimum of 0 (the default), a user may enter a valid password containing only characters from that class and pass the strength check. Therefore, it is recommended that the administrator configure all four minimum strength check character classes if password strength checking is desired. Use the minimum character class check to require the user to enter a password that passes the minimum strength check for more than one minimum strength check character class. Minimum character class checking validates passwords that contain a character matching a configured character class. If minimum character class checking is enabled, a password must pass at least the minimum number of configured minimum strength class checks to be valid. Non-configured minimum character classes are not counted towards the minimum matching character classes. If minimum character class checking is disabled and if a password contains a character matching a configured character class, it must meet the specific minimum strength check limit for the matching character class. If the password only contains characters that are in non-configured (0 limit) minimum strength check character class, the password is considered valid. If the maximum consecutive characters or maximum repeated characters limits, or other validation checks are configured, passwords must pass these tests regardless of the minimum character class checking setting. passwords strength minimum uppercase-letters Use this command to enforce a minimum number of uppercase letters that a password must contain. The valid range is 0-16. The default is 1. A minimum of 0 means no restriction on that set of characters. Use the no form of the command to reset the minimum uppercase letters to the default value. Security Commands 1204