Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.7 - Page 764

match any Use the match any command in Class-Map Configuration mode to allow matching on any of the specified match conditions. Use the no form of the command to remove the ACL match criteria and revert to match-all behavior. Syntax match any no match any Default Configuration The default matching for a class map is to match on all specified match conditions. Command Mode Class-Map Configuration mode User Guidelines The clauses in an access-list referenced in a class-map are used solely to match (or not match) traffic. Access-groups identified in a class-map are matched in order of appearance in the class-map declaration (regardless of ACL number). ACLs in an access-group are matched in order of ACL number. Unlike the match all condition, when a class-map contains the match any condition, the first match for a permit or deny immediately exits the matching activity for the class-map. Conceptually, the permit/deny clauses in the access group are applied sequentially. In the match all scenario, the permit/deny clauses in the access group are applied in parallel, and all conditions must match for the matching activity to exit. For this reason, it is not advised to mix permit and deny clauses within an access-group used in a match all class map. Command History Command introduced in version 6.5 firmware. Layer 2 Switching Commands 764