Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.7 - Page 717

The remote capture application listens on the configured TCP port for a connection request. Wireshark must send a request to that port to establish a connection. Once the socket connection to Wireshark has been established, captured CPU packets are written to the data socket. Wireshark receives the packets and processes them locally. This continues until the session is terminated by either end. The following Wireshark request packets are supported: • Request to list all the remote interfaces • Request to open a remote device • Request to start a capture on a remote device • Request to close the connection with the remote peer • Message that keeps the authentication parameters • Request to get network statistics • Request to stop the current capture, keeping the device open The following Wireshark replies are supported: • Reply that sends the list of all the remote interfaces • Reply that the remote device has been opened correctly • Reply that capturing has started correctly • Reply that says 'ok, authorization successful' • Reply that keeps network statistics • Reply that confirms capturing stopped successfully Remote capture is not supported for packets received via out-of-band ports. Example This example sends capture output to the console. console(config)#monitor capture line console(config)#exit console#monitor capture start all Layer 2 Switching Commands 717