Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.7 - Page 2243

Lowering the sampling rate (higher numerical value) will help to ensure that all collected samples can be sent to the receiver. The sflow instance must be configured using the sflow destination owner command before this command can successfully execute. Example console(config)#sflow 1 sampling gigabitethernet 1/0/2 1500 50 sflow sampling (Interface Mode) Use the sflow sampling command in Interface Mode to enable a new sflow sampler instance for this data source if rcvr_idx is valid. Use the no form of this command to reset sampler parameters to the default. Syntax sflow rcvr-index sampling sampling-rate [size] no sflow rcvr-index sampling • rcvr-index - The sFlow Receiver for this sFlow sampler to which flow samples are to be sent. If no receiver is configured, then no packets will be sampled. Only active receivers can be set. If a receiver expires, then all samplers associated with the receiver will also expire. (Range: 1 - 8). • sampling-rate - The statistical sampling rate for packet sampling from this source. A sampling rate of 1 counts all packets. A rate of 0 disables sampling. A value of n means that out of n incoming packets, 1 packet will be sampled. (Range: 1024 - 65536). • size - The maximum number of bytes that should be copied from the sampler packet (Range: 20 - 256 bytes). Default Configuration There are no samplers configured by default. There is no default sampling rate. The default maximum header size is 128. Command Mode Interface Configuration (Ethernet) mode Switch Management Commands 2243