Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.7 - Page 1727

type 3 summary LSA is not advertised, but contained networks are suppressed. This behavior is equivalent to specifying the not-advertise option. If the range is configured for type 7 to type 5 translation, a type 5 LSA is sent if the metric is set to 16,777,215; however, other routers will not compute a route from a type 5 LSA with this metric. Default Configuration No area ranges are configured by default. No cost is configured by default. Command Mode OSPFv2 Router Configuration mode User Guidelines The no form of this command can be used to delete an area range. For example: !! Create area range console (config-router)#area 1 range 10.0.0.0 255.0.0.0 summarylink !! Delete area range console (config-router)#no area 1 range 10.0.0.0 255.0.0.0 summarylink The no form may be used to revert the [advertise | not-advertise] option to its default without deleting the area range. Deleting and recreating the area range would cause OSPF to temporarily advertise the prefixes contained within the range. Note that using either the advertise or not-advertise keyword reverts the configuration to the default. For example: !! Create area range. Suppress summary. console (config-router)#area 1 range 10.0.0.0 255.0.0.0 summarylink notadvertise !! Advertise summary. console (config-router)#no area 1 range 10.0.0.0 255.0.0.0 summarylink notadvertise The no form may be use to remove a static area range cost, so that OSPF sets the cost to the largest cost among the contained routes. For example: !! Create area range with static cost. console (config-router)#area 1 range 10.0.0.0 255.0.0.0 summarylink cost 1000 !! Remove static cost. console (config-router)#no area 1 range 10.0.0.0 255.0.0.0 summarylink cost Layer 3 Routing Commands 1727