Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.7 - Page 313

• interface-id-The interface to which the received packet is forwarded. Ethernet interface identifiers and port channel identifiers are valid for this command. Default Configuration No static addresses are defined. The default mode for an added address is permanent. Command Mode Global Configuration mode User Guidelines The MAC address may be a unicast or multicast MAC address. Static MAC addresses are never overridden by dynamically learned addresses. This has implications for protocols like IGMP snooping, where statically configuring the MAC address of a multicast router keeps IGMP snooping from dynamically adding the multicast router to a different port. The maximum number of static MAC addresses that may be configured on a port is limited by the switchport port-security maximum command. This command may be invoked multiple times with different interfaces (and the same VLAN) when used with a multicast MAC address. Example The following example adds a permanent static MAC address c2f3.220a.12f4 to the MAC address table. console(config)# mac address-table static c2f3.220a.12f4 vlan 4 interface gigabitethernet6/0/1 switchport port-security (Global Configuration) Use the switchport port-security command in Global Configuration mode to enable port security globally. Use the no form of the command to disable port security globally. Syntax switchport port-security Layer 2 Switching Commands 313