Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.7 - Page 2222

Command Modes Global Configuration mode User Guidelines The configuration parameters are not validated when this command is entered. Use the write core test command to validate the configured parameters and that the core dump is likely to succeed. An average core file is around 450 KB. Example copy times are as follows: • TFTP: 13mins (different subnet) • USB: 3 mins Administrators should ensure that a cleanly formatted USB flash drive of at least 1G is used for collection of a the full core dump. Do not remove the USB device during data transfer. Use the unmount command to cleanly detach the USB device prior to physical removal. Example This example enables core dumps to a TFTP server 10.27.9.1 reachable over the out-of-band port. The core file is written to the dumps directory and the name includes the host name of the switch and the switch TOD. console(config)#exception dump tftp-server 10.27.9.1 file-path dumps console(config)#exception core-file hostname time-stamp console(config)#exception protocol tftp exception dump Use this command to configure the core dump location. Use the no form of the command to reset the location and parameters to the default values. Syntax exception dump {tftp-server ip-address | ftp-server ip-address [username user-name {nopassword | password password} ] | file-path dir | compression | stack-ip-address [protocol {dhcp | static} | add ip-address netmask [gateway]] no exception dump {tftp-server | file-path} • ip-address-The IPv4 address of a TFTP server. Switch Management Commands 2222