Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.7 - Page 719

• mode-Enable session mirroring. Use the no form of the command to disable monitoring. • remove-rspan-tag-Remove the RSPAN tag from packets transmitted on the probe port. Default Configuration The default is to mirror both transmit and receive directions. If neither tx or rx is configured, both directions are monitored. Command Mode Global Configuration mode User Guidelines Use the source interlace parameter to specify the interface to monitor. Use rx to monitor only ingress packets, or use tx to monitor only egress packets. If you do not specify an rx or tx option, the session monitors both ingress and egress packets. Use the destination interface to specify the interface to receive the monitored traffic. Use the mode parameter to enabled the administrative mode of the session. If enabled, the destination (probe) port monitors all the traffic received and transmitted on the physical monitored port. The probe port should not be connected to a network. Connect it to a monitoring tool or a standalone (static IP address) workstation running a monitoring program. Up to four sessions mirroring traffic in a single direction and with unique destinations are supported on the Dell EMC Networking N2000, N2100-ON, N2200-ON, N3000-ON, N3100-ON, and N3200-ON Series switches. The Dell EMC Networking N1100-ON and N1500 Series switches support a single unidirectional or bidirectional session. Each session supports multiple sources. However, the destination interface for a session may not overlap with other sessions. The internal CPU port cannot be configured as an RSPAN source. The session limitations are as follows (N2000, N2100-ON, N2200-ON, N3000-ON, N3100-ON, and N3200-ON only): • Up to 4 sessions in ingress (RX) traffic mirroring may be active. • Up to 4 sessions with egress (TX) traffic mirroring may be active. • Up to 2 sessions with both (RX and TX) traffic mirroring may be active. Layer 2 Switching Commands 719