Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.7 - Page 910

switchport trunk Use the switchport trunk command in Interface Configuration mode to configure VLAN membership for a trunk port or to set the native VLAN for an interface in Trunk Mode. Syntax switchport trunk {allowed vlan vlan-list | native vlan vlan-id} no switchport trunk { allowed | native } vlan • vlan-list-Set the list of allowed VLANs that can receive and send traffic on this interface in tagged format when in trunking mode. The default is all. The vlan-list format is as follows: The vlan-list format is all | [add | remove | except] vlan-atom [, vlan-atom...] where: - all specifies all VLANs from 1 to 4093. This keyword is not allowed on commands that do not permit all VLANs in the list to be set at the same time. - add adds the defined list of VLANs to those currently set instead of replacing the list. - remove removes the defined list of VLANs from those currently set instead of replacing the list. Valid IDs are from 1 to 4093; extendedrange VLAN IDs of the form X-Y or X,Y,Z are valid in this command. - except lists the VLANs that should be calculated by inverting the defined list of VLANs. (VLANs are added except the ones specified.) - vlan-atom is either a single VLAN number from 1 to 4093 or a continuous range of VLANs described by two VLAN numbers, the lesser one first, separated by a hyphen. • valid-id-A valid VLAN id in the range 1-4093. This is the native VLAN for the trunk port and will accept and send traffic on this VLAN in untagged format. Default Configuration A trunk port is a member of all VLANs by default. Layer 2 Switching Commands 910