Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.7 - Page 2406

• oldunit - The current switch identifier. (Range: Dependent on Series/Model) • newunit - The updated value of the switch identifier. (Range: Dependent on Series/Model) Command Mode Global Configuration mode User Guidelines Upon execution, the switch is configured with the configuration information for the new switch if any is available. The old switch configuration information is retained; however, the original switch will be operationally detached. This means the interfaces show as detached in show interfaces status output and no switch type will show for the Plugged-in Model Id in the output of the show switch command. This command may be executed on the management unit in the stack or a standalone unit. This command reboots the renumbered switch. After renumbering a switch, it is important to let the primary switch synchronize the NSF state before proceeding with additional stack management operations. Use the show nsf command to check the NSF state. If the switch shows Warm Restart Ready as Yes, then the primary switch state is synchronized with the standby switch. Failure to observe this caution may result in the primary unit spontaneously resetting due to configuration mismatch in order to re-elect a primary unit. The range of switch numbers is 1 to maximum stack size. The maximum stack size varies, depending on the switch model. The switch renumber command prompt will display the valid range. Example The following example displays how to reconfigure switch number "1" to an identifier of "2." console(config)#switch 1 renumber 2 telnet Use the telnet command to log into a host that supports Telnet. Switch Management Commands 2406