Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.7 - Page 2024

Default Configuration This command has no default configuration. Command Mode Privileged Exec, Global Configuration mode and all Configuration submodes User Guidelines This command lists all IPv4 addresses currently leased from a DHCP server on an IP interface. This command only applies to IP interfaces. To see the IPv4 address leased on the out-of-band interface, use the command Maximum Next Hops 16 out-of-band. This command output provides the following information. Term Description IP address, Subnet The IP address and network mask leased from the DHCP server. mask DHCP Lease server The IPv4 address of the DHCP server that leased the address. State State of the DHCPv4 Client on this interface. DHCP transaction The transaction ID of the DHCPv4 Client. id Lease The duration that the IP address was leased by the server. Renewal The time when the next DHCP renew Request is scheduled to renew the leased IP address. Rebind The time when the DHCP Rebind process is scheduled. Retry count Number of times the DHCPv4 client sent a DHCP REQUEST message to which the server did not respond. Examples The following example shows the output from this command when the device has leased two IPv4 addresses from the DHCP server. console#show dhcp lease IP address: 10.27.22.186 on interface Vl1 Subnet mask: 255.255.252.0 DHCP lease server: 10.27.192.22, State: 5 Bound DHCP transaction id: 0xc9e6803a Switch Management Commands 2024