Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.7 - Page 1565

Parameter Description OSPF Admin Mode Whether OSPF is enabled or disabled globally. Maximum Paths The maximum number of next hops in an OSPF route. Routing for Networks The address ranges configured with an OSPF network command. Distance The administrative distance (or "route preference") for intraarea, inter-area, and external routes. Default Route Advertise Whether OSPF is configured to originate a default route. Always Whether default advertisement depends on having a default route in the common routing table. Metric The metric configured to be advertised with the default route. Metric Type The metric type to advertise for redistributed routes of this type. Redist Source The type of routes OSPF is redistributing. Metric The metric to advertise for redistributed routes of this type. Metric Type The metric type to advertise for redistributed routes of this type. Subnets Whether OSPF redistributes subnets of classful addresses, or only classful prefixes. Dist List A distribute list used to filter routes of this type. Only routes that pass the distribute list are redistributed. Number of Active The number of OSPF areas with at least one interface running Areas on this router. Also broken down by area type. ABR Status The number of OSPF areas with at least one interface running on this router. Also broken down by area type. ASBR Status Whether the router is an autonomous system boundary router. The router is an ASBR if it is redistributing any routes or originating a default route. RIP Section RIP Admin Mode Whether RIP is globally enabled. Split Horizon Mode Whether RIP advertises routes on the interface where they were received. Layer 3 Routing Commands 1565