Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.7 - Page 1746

Syntax distance ospf {[intra-area dist1] [inter-area dist2] [external dist3]} no distance ospf {intra-area | inter-area | external} • intra-area dist1-Used to select the best path within an area when there are two or more routes to the same destination from two different routing protocols (Range: 1-255). • inter-area dist2-Used to select the best path from one area to another area when there are two or more routes to the same destination from two different routing protocols (Range: 1-255). • external dist3-Used to select the best path for routes from other routing domains, learned by redistribution when there are two or more routes to the same destination from two different routing protocols (Range: 1-255). Default Configuration The default preference value is 110 for dist1, dist2 and dist3. Command Mode Router OSPF Configuration mode. Router OSPFv3 Configuration mode. User Guidelines There are no user guidelines for this command. Examples The following examples set route preference values of OSPF in the router. console(config-router)#distance ospf intra 4 console(config-router)#distance ospf type1 19 distribute-list out Use the distribute-list out command in Router OSPF Configuration mode to specify the access list to filter routes received from the source protocol. Use the no form of the command to remove the specified source protocol from the access list. Layer 3 Routing Commands 1746