Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.7 - Page 1928

Command Mode Interface Configuration (VLAN) mode. User Guidelines This command has no user guidelines. Example The following example adds VLAN 2 to the virtual router tracked list (with a priority decrement value of 20.) (config-if-vlan10)#vrrp 1 track interface vlan 2 decrement 20 vrrp track ip route Use the vrrp track ip route command to track the route reachability. When the tracked route is deleted, the priority of the VRRP router is decremented by the value specified in the priority argument. When the tracked route is added, the priority is incremented by the same. A VRRP configured interface can track more than one route. When a tracked route goes down, the priority of the router is decreased by 10 (default priority decrement) for each downed route. By default no routes are tracked. If we specify just the route to be tracked without specifying the optional parameter, then the default priority will be set. Use the no form of this command to remove the route from the tracked list or to restore the priority decrement to its default. When removing a tracked IP route from the tracked list, priority should be incremented by the decrement value if the route is not reachable. Syntax vrrp group track ip route ip-address/prefix-length [decrement priority] no vrrp group track ip route ip-address/prefix-length • group-The virtual router identifier. (Range: 1-255). • ip-address/prefix-length-Specifies the route to be tracked. • priority-Priority decrement value for the tracked route. (Range: 1-254). Layer 3 Routing Commands 1928