Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.7 - Page 783

- set-dscp-transmit dscp-val- Remark the DSCP in the packet to dscpval and transmit. (Range 0-63) - set-cos-transmit 802.1p-priority- Remark the 802.1p priority in the packet to 802.1p-priority and transmit. (Range 0-7) - transmit- Transmit the packet unmodified. Default Configuration This command has no default configuration. Command Mode Policy-Class-Map Configuration mode User Guidelines A trTCM meters a traffic stream and colors packets according to four parameters: Committed Information Rate (CIR) Committed Burst Size (CBS) Peak Information Rate (PIR) Peak Burst Size (PBS) A packet is colored red if it exceeds the PIR, yellow if it exceeds the CIR, but not the PIR, and green if it does not exceed either. A trTCM is useful when a peak rate needs to be enforced separately from a committed rate. The CIR and PIR are measured in Kbps (not pps as indicated in the RFC), the CBS in Kbytes, and the PBS in Kbytes. It is recommended that the CBS and PBS be configured to be larger than the largest expected IP packet. A class command in policy-map mode must be issued for an existing class-map before entering this command. Data rate expressed as rate-percent self-adjusts to the speed the links comes up. For example, if the rate-percent is configured as 10%, the rate is 100 Mb/s if the link comes up with 1G speed and its 1000 Mb/s if the link negotiates and comes up with 10G speed. Example console#show authentication clients Te1/0/23 Layer 2 Switching Commands 783