Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.7 - Page 1391

IPv4 Unicast Support IPv6 Unicast Support RFC 5549 Support Update Source Local Interface Address Configured Hold Time Configured Keep Alive Time Negotiated Hold Time Keep Alive Time Indicates whether IPv4 unicast routes can be exchanged with this peer. Both indicates that IPv4 is active locally and the neighbor indicated support for IPv4 unicast in its OPEN message. Sent indicates that IPv4 unicast is active locally, but the neighbor did not include this AFI/SAFI pair in its OPEN message. IPv4 unicast is always enabled locally and cannot be disabled. Indicates whether IPv6 unicast routes can be exchanged with this peer. Both and Sent have the same meaning as for IPv4. None indicates that neither the local router nor the peer has IPv6 enabled for this adjacency. Received indicates that the peer advertised the IPv6 unicast capability, but it is not enabled locally. IPv6 unicast is enabled locally using the neighbor activate command in address-family IPv6 configuration mode. Shown if support for RFC 5549 is enabled and the BGP neighbor is peered over IPv6 network. The configured value for the source IP address of packets sent to this peer. This field is only included in the output if the update source is configured. The IPv6 address used as the source IP address in packets sent to this neighbor. The time, in seconds, that this router proposes to this neighbor as the hold time The configured KEEPALIVE interval for this neighbor. The minimum configured hold time and the hold time in the OPEN message received from this neighbor. If the local router does not receive a KEEPALIVE or UPDATE message from this neighbor within this interval of time, the local router drops the adjacency. This field is only shown if the adjacency state is OPEN CONFIRM or greater. The number of seconds between KEEPALIVE messages sent to this neighbor. This field is only shown if the adjacency state is OPEN CONFIRM or greater. Layer 3 Routing Commands 1391