Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.7 - Page 2150

power inline four-pair forced Use this command to force 4-pair power feed on an interface. Use the no form of the command to use the default 2-pair power feed. Syntax power inline four-pair forced no power inline four-pair forced Default Configuration The default detection and power feed is four-pair power for ports that are capable of 60W power delivery. The default detection and power feed is Alt-A two-pair power for ports that are not capable of feeding four-pair power. Command Mode Interface Config User Guidelines Use this command when the interface is connected to a device that requires detection and power on all four pairs of wires (that is, on both the Alt-A signal and Alt-B spare pairs). This command is only available on the N2100PX-ON, N3000EP-ON, and N3100PX-ON series switches. This command is not available on the N2200PX-ON, N3200P-ON, N3200PX-ON, and N3200PXE-ON Series switches. Class D or better cabling is required for feeds in excess of 34.2W. Four pair power is supported in all management modes as follows: • In class mode, the port power limit is twice the class power. • In dynamic mode, up to 60W may be delivered depending on the switch used. • In static mode, the port is limited to the configured limit. Command History Introduced in version 6.3.0.1 firmware. Command updated in firmware release 6.6.1. Switch Management Commands 2150