Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.7 - Page 506

Use the no form of the command to return the configuration to the default. Syntax green-mode eee tx-idle-time green-mode eee tx-wake-time no green-mode eee {tx-idle-time|tx-wake-time} Default Configuration By default, the transmit idle time is 600 micro-seconds and the transmit wake time is 8 micro-seconds. Command Mode Interface Configuration mode, Interface Range Configuration mode User Guidelines The tx-idle-time parameter sets the amount of time the link must be idle before transitioning to the low power idle state. The tx-wake-time configures the delay before transitioning to the active state (and transmitting the pending packet) after transmitting a wake symbol to the link partner. The transmit idle time and transmit wake time are configured in micro-seconds. The default values are recommended unless there is good reason to adjust them. Excessive wake times may cause link congestion. Excessive idle times will reduce the savings from low power idle mode. This command is available in Ethernet interface configuration mode for copper ports that are EEE capable. Configuring the values on interfaces that do not support EEE will return an error. Command History Syntax added in 6.4 release. clear green-mode statistics Use the clear green-mode statistics command to clear: • The EEE LPI event count, and LPI duration Layer 2 Switching Commands 506