Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.7 - Page 1536

A route-map statement must contain eligible match/set conditions for policy based routing in order to be applied to hardware Valid match conditions are: match ip address , match mac-list, match length Valid set conditions are: set ip next-hop, set ip default next-hop, set ip precedence A route-map statement must contain at least one of the match and one of the set conditions specified above in order it to be eligible to be applied to hardware. If not, the route-map is not applied to hardware. An ACL referenced in a route-map may not be edited. Instead, create a new ACL with the desired changes and update the route-map with the edited ACL. Route-maps and DiffServ cannot operate on the same interface due to allocation of conflicting resources. An error is thrown to user if when configuring a route-map on an interface on which DiffServ has been previously configured. When a route map is configured on a VLAN interface and a DiffServ policy is applied on any individual member port of the same VLAN interface, the port policy (DiffServ) takes priority over the VLAN (route map) policy. Example Considering equal-access as a route-map configured earlier, the following sequence is an example of how a route map is applied to a VLAN. console(config)#interface vlan 10 console(config-if-vlan10)#ip policy route-map equal-access ip redirects Use the ip redirects command to enable the generation of ICMP Redirect messages. Use the no form of this command to prevent the sending of ICMP Redirect Messages. In global configuration mode, this command affects all interfaces. In interface configuration mode, it only affects that interface. Syntax ip redirects Layer 3 Routing Commands 1536