Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.7 - Page 270

Management ACL In addition to user access control, the system also supports filtering of management protocol packets addressed to the switch over the in-band ports. This capability allows individual hosts or subnets to access the switch using specific management protocols. The administrator defines a management profile, which identifies management protocols such as the following: • Telnet. • SSH and the keying information to use for SSH. • HTTP. • HTTPS and the security certificate to be used. • SNMPv1/v2c and the read and read/write community strings to be used. • SNMPv3 and the security information for used this protocol. For each of these management profiles, the administrator defines the list of hosts or subnets from which the management profiles may be used. The management ACL capability only applies to VLANs configured on in-band ports and may not be configured on the out-of-band management port. Other CLI Tools and Capabilities The CLI has several other capabilities associated with its primary functions. Terminal Paging The default terminal width and length for CLI displays is 79 characters and 25 lines, respectively. The length setting is used to control the number of lines the CLI will display before it pauses. For example, the CLI pauses at 24 lines and prompts the user with the --More-- or (q)uit prompt on the 25th line. The CLI waits for the user to press either or or any other key. If the user presses any key other than or , the CLI shows the next page. A key stops the display and returns to the CLI prompt. The key advances the display by one line. Use the terminal length command to change the number of lines displayed in a page. A terminal length of 0 disables pagination. This option is not recommended for serial console speeds of less than 115200. Using the CLI 270