Dell W-Series 304 Instant 6.5.1.0-4.3.1.0 CLI Reference Guide - Page 1120

Parameter Total Radio Resets Resets Beacon Fail BB check positives Resets BeacQ Stuck Resets Fatal Intr Resets RX Overrun Resets RF Gain Resets MTU Change Resets TX Timeouts POE-Related Resets External Reset PCI Fatal Intr Reset Chaimask Reset TX stat Reset TX Power Changes Channel Changes Radio Band Changes Current Noise Floor Description Total number of times the radio reset. Number of times the radio reset due to beacon failure. Number of times the radio checked for a base-band hang condition An AP's radio typically sends a beacon every 100 milliseconds. If beacons are not sent at a regular interval or the radio experiences excessive noise, the beacon queue will reset. This parameter indicates the number of queue resets. Number of time the radio was reset because the AP hardware was unresponsive. The number of radio resets due to Receive FIFO overruns. Number of radio resets due to gain changes. Number of times the radio reset due to a change in the Maximum Transmission Unit (MTU) value. Number of radio resets due to transmission timeouts (the radio doesn't transmit a signal within the required time frame.) If the radio power profile drops, an AP may not be able to support three transmit chains, and may drop to two chains only. This parameter displays the number of resets due to this type of power change. Number of times the AP has been reset because it was unplugged or its reset button was pressed. Radio reset due to PCI fatal interrupt received from radio chip. Radio reset when new chain mask is configured. Radio reset caused by inconsistent state of hardware transmit queue. Number of times the radio's transmission power changed. Number of times the radio's channel changed. Number of time the radio's band changed. The residual background noise detected by an AP. 1120| show ap debug radio-stats Dell Networking W-Series ArubaOS 6.5.x | Reference Guide