Dell W-Series 304 Instant 6.5.1.0-4.3.1.0 CLI Reference Guide - Page 187

Parameter rts-threshold Description Range reselect a parent at the earlier distance (or less) with good link quality. For example, if a mesh point disconnects from a mesh parent 2 hops away and subsequently reconnects to a mesh parent 3 hops away, then the mesh point will continue to seek a connection to a mesh parent with both an acceptable link quality and a distance of two hops or less, even if the more distant parent also has an acceptable link quality. Defines the packet size sent by mesh nodes. Mesh nodes transmitting frames larger than this threshold must issue request to send (RTS) and wait for other mesh nodes to respond with clear to send (CTS) to begin transmission. This helps prevent mid-air collisions. 256-2,346 Default 2,333 bytes Usage Guidelines Mesh radio profiles are specific to mesh nodes (APs configured for mesh) and determine the radio frequency/channel used by mesh nodes to establish mesh links and the path to the mesh portal. You can configure multiple radio profiles; however, you select and deploy only one radio profile per mesh cluster. Radio profiles, including the "default" profile, are not active until you provision your APs for mesh. If you modify a currently provisioned and running radio profile, your changes take place immediately. You do not reboot the controller or the AP. Example The following command creates a mesh radio profile named "radio2" and associates a mesh high-throughput profile named meshHT1: (host) (config) #ap mesh-radio-profile radio2 mesh-ht-ssid-profile meshHT1 Related Commands To view a complete list of mesh radio profiles and their status, use the following command: (host) (config) #show ap mesh-radio-profile To view the settings of a specific mesh radio profile, use the following command: (host) (config) #show ap mesh-radio-profile Dell Networking W-Series ArubaOS 6.5.x | Reference Guide ap mesh-radio-profile | 187