Dell W-Series 304 Instant 6.5.1.0-4.3.1.0 CLI Reference Guide - Page 2344

hide-ssid ht-ssid-profile local-probe-req-thresh max-clients max-retries max-tx-fail mcast-rate-opt mfp-capable mfp-required multicast-rate Description Range Enables or disables hiding of the SSID - name in beacon frames. Note that hiding the SSID does very little to increase security. Default disabled Name of high-throughput SSID profile to - use for configuring high-throughput support. See wlan ht-ssid-profile on page 2329. "default" APs will not respond to client probe requests if the SNR value in the probe request is less than the specified threshold value. 0-100 dB 0 dB Maximum number of wireless clients for 0-255 64 the AP. This parameter is limited to 255 clients per radio. Maximum number of retries allowed for 0-15 4 the AP to send a frame. The AP assumes the client has left and should be deauthorized when the AP detects this number of consecutive frames were not delivered because the max-retries threshold was exceeded. 0- 0 2,147,483,64 7 Enables or disables scanning of all active - stations currently associated to an AP to select the lowest transmission rate for broadcast and multicast frames. This option only applies to broadcast and multicast data frames; 802.11 management frames are transmitted at the lowest configured rate. NOTE: Do not enable this parameter unless instructed to do so by your Dell technical support representative. disabled When enabled, the SSID supports - management frame protection (MFP) capable clients and traditional clients. disabled When enabled, the SSID only supports - MFP capable clients. disabled When configured, the controller chooses the rate for video multicast frames. You can configure Modulation Coding Scheme (MCS) rates as well. MCS is an important setting because it provides for potentially greater throughput. default, 6, 9, 12, 18, 24, 36, 48, 54 Mbps mcs0-mcs15 default Dell Networking W-Series ArubaOS 6.5.x | Reference Guide wlan ssid-profile | 2344