Dell W-Series 304 Instant 6.5.1.0-4.3.1.0 CLI Reference Guide - Page 1305

Column ID Cfreq Bandwidth Channels-affected Signal-strength Duty-cycle Add-time Update-time Description l generic interferer l microwave l microwave inverter l video l xbox NOTE: For additional details about non-Wi-Fi device types shown in this table, see Non-Wi-Fi Interferers on page 1299 ID number assigned to the device by the spectrum monitor or hybrid AP radio. Spectrum monitors and hybrid APs assign a unique spectrum ID per device type. Center frequency of the signal sent from the device. Channel bandwidth used by the device. Radio channels affected by the wireless device. Strength of the signal sent from the device, in dBm. Device duty cycle. This value represents the percent of time the device broadcasts a signal. Time at which the device was first detected. Time at which the device's status was updated. Related Commands Command ap spectrum local-override Description Mode Convert an AP or AM into a spectrum monitor by adding it to the spectrum localoverride list. Config mode on master or local controllers rf dot11a-radio-profilemodespectrum-mode Set a 802.11a radio so the device operates as an spectrum monitor, and can send spectrum analysis data to a desktop or laptop client. Config mode on master or local controllers rf dot11g-radio-profilemodespectrum-mode Set a 802.11g radio so the device operates as an spectrum monitor, and can send spectrum analysis data to a desktop or laptop client. Config mode on master or local controllers Dell Networking W-Series ArubaOS 6.5.x | Reference Guide show ap spectrum device-list | 1305