Dell W-Series 304 Instant 6.5.1.0-4.3.1.0 CLI Reference Guide - Page 1843

Parameter Minimum Scan Time Description Time, in seconds, that a channel must be scanned before it is considered for assignment. Load aware Scan Threshold The traffic throughput level an AP must reach before it stops scanning, in bytes/second. A value of 0 to disables this feature. Mode Aware Arm If enabled, ARM will turn APs into Air Monitors (AMs) if it detects higher coverage levels than necessary. This helps avoid higher levels of interference on the WLAN. Although this setting is disabled by default, you may want to enable this feature if your APs are deployed in close proximity (e.g. less than 60 feet apart). Scan Mode This parameter defines the scan mode for the AP. l all-reg-domain: The AP scans channels within all regulatory domains. This is the default setting. l reg-domain:Limit the AP scans to just the regulatory domain for that AP. Client Match The client match feature helps optimize network resources by balancing clients across channels, regardless of whether the AP or the controller is responding to the wireless clients' probe requests. If enabled, the controller compares whether or not an AP has more clients than its neighboring APs on other channels. If an AP's client load is at or over a predetermined threshold as compared to its immediate neighbors, or if a neighboring Dell AP on another channel does not have any clients, load balancing will be enabled on that AP. This feature is enabled by default Client Match report interval (sec) This interval defines how often an AP sends an updated client probe report to the controller. Each client probe report contains a list of MAC addresses for clients that have been active in the last two minutes, and the AP radio SNR values seen by those clients. Allows Client Match to Automatically Clear Unsteerable Clients after Ageout When client match and the client match unsteerable client ageout features are enabled, the controller periodically sends APs that are not a desired AP match for a client in a list of unsteerable clients. These lists contain a list of MAC addresses for up to 128 clients that should not be steered to that AP. Client Match Unsteerable Client Ageout Interval The client entries in an unsteerable client list remain in effect for the interval defined by this parameter before they age out. Client Match Band Steering G Max Signal (-dBm) Maximum signal level of the G band radio that can trigger a Client Match band steer move (-dBm) Client Match Band Steering A Min Signal (-dBm) Minimum signal level required for the targeted A band radio in a Client Match band steer move (-dBm). Client Match Sticky Client Check Interval (sec) Frequency at which the AP checks for client's received SNR values. If the SNR value drops below the threshold defined by the cm-sticky-snr parameter for three consecutive check intervals, that client may be moved to an different AP. Dell Networking W-Series ArubaOS 6.5.x | Reference Guide show rf arm-profile | 1843