Dell W-Series 304 Instant 6.5.1.0-4.3.1.0 CLI Reference Guide - Page 208

ap spectrum local-override no override ap-name spectrum-band 2ghz|5ghz Description Convert an AP or AM into a spectrum monitor by adding it to the spectrum local-override list. Syntax Parameter Description Range override ap-name name of an AP whose - radio should be converted to a spectrum monitor radio Default - spectrum band Spectrum band or portion of the band to be monitored by the spectrum monitor radio 2GHz (channels 1-14) 5GHz(channels 36-64, 100140 and 149-165). 2Ghz Usage Guidelines There are two ways to change an AP that supports the spectrum monitor feature into a spectrum monitor. You can assign that AP to a 802.11a and 802.11g radio profile that is already set to spectrum mode, or you can temporarily change the AP into a spectrum monitor using a local spectrum override profile. When you use a local spectrum override profile to override an AP's mode setting, that AP will begin to operate as a spectrum monitor, but will remain associated with its previous 802.11a and 802.11g radio profiles. If you change any parameter (other than the overridden mode parameter) in the spectrum monitor's 802.11a or 802.11 radio profiles, the spectrum monitor will immediately update with the change. When you remove the local spectrum override, the spectrum monitor will revert back to its previous mode, and remain assigned to the same 802.11a and 802.11 radio profiles as before. For a list of APs that can be converted into a spectrum monitor or hybrid AP, refer to the Spectrum Analysis chapter of the Dell Networking W-Series ArubaOS 6.5.x User Guide. Related Commands Command show ap spectrum localoverride Description Mode This command shows a list of AP radios currently converted to spectrum monitors via the spectrum local-override list Config mode on master or local controllers Dell Networking W-Series ArubaOS 6.5.x | Reference Guide ap spectrum local-override | 208