Dell W-Series 304 Instant 6.5.1.0-4.3.1.0 CLI Reference Guide - Page 185

Parameter mesh-survivability metricalgorithm best-linkrssi distributedtree-rssi mpv no reselection-mode reselect-anytime Description Best practices are to use the default value. Range Default Allow mesh points and portals to become - active even if the controller cannot be reached by bridging LAN traffic. This is a beta feature that is disabled by default; it should not be enabled unless you are instructed to do so by Dell technical suppport. distributedtreerssi Specifies the algorithm used by a mesh - node to select its parent. Best practices are to use the default value distributed-tree-rssi. distributedtreerssi Selects the parent with the strongest RSSI, - - regardless of the number of children a potential parent has. Selects the parent based on link-RSSI and - - node cost based on the number of children. This option evenly distributes the mesh points over high quality uplinks. Low quality uplinks are selected as a last resort. This parameter is experimental and reserved for future use. 0-4094 0 (disabled) Negates any configured parameter. - - Specifies the method used to find a better mesh link. Best practices are to use the default value startup-subthreshold. (see below) startup-sub threshold Mesh points using the reselect-anytime - - reselection mode perform a single topology readjustment scan within 9 minutes of startup and 4 minutes after a link is formed. If no better parent is found, the mesh point returns to its original parent. This initial scan evaluates more distant mesh points before closer mesh points, and incurs a dropout of 5-8 seconds for each mesh point. Dell Networking W-Series ArubaOS 6.5.x | Reference Guide ap mesh-radio-profile | 185