Dell W-Series 304 Instant 6.5.1.0-4.3.1.0 CLI Reference Guide - Page 263

cfgm cfgm {set config-chunk |set heartbeat |set maximum-updates |snapshottimer |sync-command-blocks |sync-typecomplete|sync-type snapshot} Description This command configures the configuration module on the master controller. Syntax Parameter set config-chunk set heartbeat set maximum-updates snapshot-timer sync-command-blocks sync-type complete sync-type snapshot Description Range Maximum packet size, in Kilobytes, that is sent every second to the local controller whenever the master controller sends a configuration to the local. If the connection between the master and local is slow or uneven, you can lower the size to reduce the amount of data that needs to be retransmitted. If the connection is very fast and stable, you can increase the size to make the transmission more efficient. 1-100 Interval, in seconds, at which heartbeats are sent. You can increase the interval to reduce traffic load. 10-300 Maximum number of local controllers that can be updated at the same time with configuration changes. You can decrease this value if you have a busy network. You can increase this value to improve configuration synchronization. 2-25 Interval, in minutes, that the local controller waits for a configuration download from the master upon bootup or startup before loading the last snapshot configuration. 5-60 To configure the number of command-list blocks. Each block contains a list of global configuration commands for each write-mem operation. 3-10 The master sends full configuration file to the - local. The master sends only the incremental con- - figuration to the local. NOTE: By default, this configuration is enabled. Default 10 Kbytes 10 seconds 5 5 minutes 5 - Enable Dell Networking W-Series ArubaOS 6.5.x | Reference Guide cfgm | 263