Dell W-Series 304 Instant 6.5.1.0-4.3.1.0 CLI Reference Guide - Page 1841

Parameter Allowed bands for 40MHz channels 80MHz support 160MHz-support Client Aware Max Tx Power Min Tx Power Multi Band Scan Rogue AP Aware Scan Interval Aggressive Scanning Active Scan Description Shows if 40 MHz mode of operation is allowed on the 5 GHz (802.11a) or 2.4 GHz (802.11b/g) frequency band only, on all frequency bands, or on neither frequency band. Displays the status if 80 MHz channels can be used in the 5 GHz frequency band on APs that support 802.11ac. Displays the channel bandwidth mode on the 160 MHz frequency. Shows if the client aware feature is enabled or disabled. When enabled, the AP does not change channels when there are active clients. The highest transmit power levels for the AP, from 0-30 dBm in 3 dBm increments. Higher power level settings may be constrained by local regulatory requirements and AP capabilities. In the event that an AP is configured for a Max Tx Power setting it cannot support, this value will be reduced to the highest supported power setting. The lowest transmit power levels for the AP, from 0-30 dBm, in 3 dBm increments. Note that power settings will not change if the Assignment option is set to disabled or maintain. If enabled, single-radio APs will try to scan across bands for rogue AP detection. If enabled, Dell APs may change channels to contain off-channel rogue APs with active clients. This security features allows APs to change channels even if the Client Aware setting is disabled. This setting is disabled by default, and should only be enabled in highsecurity environments where security requirements are allowed to consume higher levels of network resources. You may prefer to receive Rogue AP alerts via SNMP traps or syslog events. If Scanning is enabled, the Scan Interval defines how often the AP will leave its current channel to scan other channels in the band. Off-channel scanning can impact client performance. Typically, the shorter the scan interval, the higher the impact on performance. If you are deploying a large number of new APs on the network, you may want to lower the Scan Interval to help those APs find their optimal settings more quickly. Raise the Scan Interval back to its default setting after the APs are functioning as desired. When the aggressive scanning feature is enabled, an AP radio with no clients will scan channels every second. If enabled, the AP initiates active scanning via probe request. This option elicits more information from nearby APs, but also creates additional management traffic on the network. Active Scan is disabled by default, and should not be enabled except under the direct supervision of Dell Support. Dell Networking W-Series ArubaOS 6.5.x | Reference Guide show rf arm-profile | 1841