Dell W-Series 304 Instant 6.5.1.0-4.3.1.0 CLI Reference Guide - Page 755

Parameter tpc-power tx-power very-high-throughput-ratesenable Description Range The transmit power advertised in the TPC IE of beacons and probe responses. Range: 0-51 dBm 0-51 dBm Sets the initial transmit power (dBm) on which the AP operates, unless a better choice is available through calibration. This parameter can be set from 0 to 51 in .5 dBm increments, or set to the regulatory maximum value of 127 dBm. Transmission power may be further limited by regulatory domain constraints and AP capabilities. 0-51 dBm, 127 dBm This feature enables Very High - Throughput (VHT) rates on the 2.4 GHz band, providing 256QAM modulation and encoding that allows for 600 Mbit/sec performance over 802.11n networks. Maximum data rates are increased on the 2.4 GHz band through the addition of VHT Modulation and Coding Scheme (MCS) values 8 and 9, which support the highly efficient modulation rates in 256-QAM. Starting with ArubaOS 6.4.2.0, VHT is supported on W-AP220 Series access points on both 20 and 40 MHz channels. Using the controller's CLI or WebUI, VHT MCS values 0-9 are enabled, overriding the existing high-throughput (HT) MCS values 0-7, which have a lower maximum data rate. However, this feature should be disabled if individual rate selection is required. Default 15 dBm 14 dBm disabled Usage Guidelines This command configures radios that operate in the 2.4 GHz frequency band, which includes radios utilizing the IEEE 802.11b/g or IEEE 802.11n standard. Channels must be valid for the country configured in the AP regulatory domain profile (see ap regulatory-domain-profile on page 202).To view the supported channels, use the show ap allowed-channels command. APs initially start up with default ack-timeout, cts-timeout and slot-time values. When you modify the maximum-distance parameter in an rf dot11a radio profile or rf dot11g radio profile, new ack-timeout, cts- 755| rf dot11g-radio-profile Dell Networking W-Series ArubaOS 6.5.x | Reference Guide