Dell W-Series 304 Instant 6.5.1.0-4.3.1.0 CLI Reference Guide - Page 1288

show ap spectrum debug show ap spectrum debug {channel-info|channel-quality|classify|classify-fft|devicedetails|device-info|devices-seen} {ap-name }|{ip-addr } freq-band {2.4ghz|5ghz} Description This command saves spectrum analysis channel information to a file on the spectrum monitor. Syntax Parameter channel-info channel-quality classify classify-fft device-details device-info devices-seen ap-name ip-addr freq-band 2.4ghz|5ghz Description Save channel information for later analysis. Save channel quality information for later analysis Save information on classification for later analysis. Save information on classification and FFT data for later analysis. Save device details for later analysis. Save device information for later analysis. Save information on devices seen by the spectrum monitor. Name of the spectrum monitor for which you want to view spectrum information. IP address of the spectrum monitor for which you want to view spectrum information. Save information for a specific radio type, either 2.4 GHz or 5 GHz. Usage Guidelines Use this command under the supervision of your Dell technical support representative to troubleshoot spectrum analysis issues or errors. If a dump-server is defined in the AP's AP system profile, the file created by this command will be sent from the AP to the dump-server using TFTP. Related Commands Command ap spectrum local-override Description Mode Convert an AP or AM into a spectrum monitor by adding it to the spectrum localoverride list. Config mode on master or local controllers Dell Networking W-Series ArubaOS 6.5.x | Reference Guide show ap spectrum debug | 1288