Dell W-Series 304 Instant 6.5.1.0-4.3.1.0 CLI Reference Guide - Page 2139

show wms monitor-summary show wms channel stats Description Display the numbers of different AP and client types monitored over the last 5 minutes, 1 hour, and since the controller was last reset. Syntax No parameters. Usage Guidelines The WLAN management system (WMS) on the controller monitors wireless traffic to detect any new AP or wireless client station that tries to connect to the network. When an AP or wireless client is detected, it is classified and its classification is used to determine the security policies which should be enforced on the AP or client. Use the show wms monitor-summary command to view a quick summary of each classified AP and client type currently on the network. If AP learning is enabled (with the wms general command), non-Dell APs connected on the same wired network as Dell APs are classified as valid APs. If AP learning is disabled, a non-Dell AP is classified as an unsecure or suspect-unsecure AP. Example This example shows that the controller currently has 144 valid APs and 32 active valid clients, and verifies that the controller currently aware of a single disabled rogue AP. (host) #show wms monitor-summary WMS Monitor Summary Last 5 Min Last Hour All - Valid APs 1 1 1 Interfering APs 57 57 60 Rogue APs 3 3 3 Manually Contained APs 0 0 0 Unclassified APs 0 0 0 Neighbor APs 0 0 0 Suspected Rogue APs 138 138 139 Valid Clients 0 0 0 Interfering Clients 1 1 1 Manually Contained Clients 0 0 0 Dell Networking W-Series ArubaOS 6.5.x | Reference Guide show wms monitor-summary | 2139