Dell W-Series 304 Instant 6.5.1.0-4.3.1.0 CLI Reference Guide - Page 972

I: Interference, R: Radar detection, N: Noise exceeded, Q: Bad Channel Quality E: Error threshold exceeded, INV: Invalid Channel, G: Rogue AP Containment, M: Empty Channel, P+: Increase Power, P-: Decrease Power, 40INT: 40MHZ intol detected on 2.4G, NO40INT: 40MHz intol cleared on 2.4G, OFF: Turn off Radio, ON: Turn on Radio, D: Dynamic Bandwidth Switch, I*: CCA Interference The output of this command includes the following information: Parameter Time of Change Old Channel New Channel Old Power New Power Reason Result Description Time elapsed since the change, in the format yyyy-mm-dd hours:minutes:seconds. Channel number used by the AP interface before the ARM change. Channel number used by the AP interface after the ARM change. Power level of the AP interface before the ARM change. Power level of the AP interface after the ARM change. This column displays one of the following code to indicate why the channel or power change was made. l I: Interference l R: Radar detected l N: Noise exceeded l E: Error threshold exceeded l INV: Invalid Channel l G: Rogue AP Containment l M: Empty Channel l P+: Increase Power l P-: Decrease Power l OFF: Turn off Radio l ON: Turn on Radio The Reason key appears at the bottom of the ARM History table. This column displays if the previous ARM request of channel or Equivalent Isotropically Radiated Power (EIRP) change is accepted, and the radio is configured accordingly. This column can have the following values: l Configured: ARM's channel or EIRP change request is applied to the radio. l Not accepted: ARM's channel or EIRP change request is not accepted. This may be due to a loss of the request message, a loss of the configuration message, full station management queue, or more. l Overridden: Request is sent; but radio configuration applied is different from the one that was requested. l -: Feedback unidentified. 972| show ap arm history Dell Networking W-Series ArubaOS 6.5.x | Reference Guide