Dell W-Series 304 Instant 6.5.1.0-4.3.1.0 CLI Reference Guide - Page 1203

0 0 0 HT-40MHzsgi-2ss sw-ad-GB32 Total count: 5, Children: 2 Relation: P = Parent; C = Child; N = Neighbor; B = Blacklisted-neighbor Flags: R = Recovery-mode; S = Sub-threshold link; D = Reselection backoff; F = Auth-failure; H = High Throughput; L = Legacy allowed The output of this command includes the following information: Column MAC Portal Channel Age Hops Cost Relation Flags RSSI Rate Tx/Rx Description MAC address of the mesh node. By default, this column displays the BSSID of the mesh point. If you include the optional names parameter, this column will display AP names, if available. The AP names will include [p] (parent), or [c] (child) suffixes to indicate the role of the mesh BSSID. Number of a radio channel used by the AP. Number of seconds elapsed since the AP heard from the neighbor. Indicates the number of hops it takes traffic from the mesh node to get to the mesh portal. The mesh portal advertises a hop count of 0, while all other mesh nodes advertise a cumulative count based on the parent mesh node A relative measure of the quality of the path from the AP to the controller. A lower number indicates a better quality path, where a higher number indicates a less favorable path (e.g, a path which may be longer or more congested than a path with a lower value.) For a mesh point, the path cost is the sum of the (parent path cost) + (the parent node cost) + (the link cost). Shows the relationship between the specified AP and the AP on the neighbor list and the amount of time that relationship has existed. l P = Parent l C = Child l N = Neighbor l B = Blacklisted-neighbor This parameter shows additional information about the mesh neighbor. The key describing each flag appears at the bottom of the neighbor list. The Receive Signal Strength Indicator (RSSI) value displayed in the output of this command represents signal strength as a signal to noise ratio. For example, a value of 30 would indicate that the power of the received signal is 30 dBm above the signal noise threshold. The rate, in Mbps, that a neighbor transmits data to or receives data from the mesh-node specified by the command. 1203| show ap mesh neighbors Dell Networking W-Series ArubaOS 6.5.x | Reference Guide