Dell W-Series 304 Instant 6.5.1.0-4.3.1.0 CLI Reference Guide - Page 2378

wms ap wms ap mode {interfering|manually-contained|neighbor|rogue|suspected-rogue|valid} Description This command allows you to classify an AP into one of several categories. Syntax Parameter Description BSSID of the AP. mode Classify the AP into one of the following categories. interfering An AP seen in the RF environment but is not connected to the wired network. manually-contained Manually enable denial of service from this AP neighbor An neighboring AP whose BSSID is known. suspected-rogue A suspected rogue AP that is plugged into the wired side of the network but may not be an unauthorized device. Automatic shutdown of rogue APs does not apply to these devices. rogue A rogue AP that is unauthorized and is plugged into the wired side of the network. You can configure automatic shutdown of rogue APs in the IDS unauthorized device detection profile. valid An AP that is part of the enterprise providing WLAN service. Usage Guidelines If AP learning is enabled (with the wms general learn-ap enable command), non-Dell APs connected on the same wired network as Dell APs are classified as valid APs. If AP learning is disabled, a non-Dell AP is classified as an unsecure or suspect-unsecure AP. Example The following command classifies an interfering AP as a known-interfering AP: (host) #wms ap 01:00:00:00:00:00 mode known-interfering Dell Networking W-Series ArubaOS 6.5.x | Reference Guide wms ap | 2378