Dell W-Series 304 Instant 6.5.1.0-4.3.1.0 CLI Reference Guide - Page 1849

Parameter Spur Immunity Description Displays the spur immunity value for 802.11a radio. NOTE: This parameter is applicable for W-AP130 Series access points only. The controller ignores this parameter if configured for non-W-AP130 Series access points. Advertise 802.11d and 802.11h Capabilities If enabled, the radio advertises its 802.11d (Country Information) and 802.11h (Transmit Power Control) capabilities. TPC Power The transmit power advertised in the TPC IE of beacons and probe responses Spectrum load balancing The Spectrum load balancing feature helps optimize network resources by balancing clients across channels, regardless of whether the AP or the controller is responding to the wireless clients' probe requests. If enabled, the controller compares whether or not an AP has more clients than its neighboring APs on other channels. If an AP's client load is at or over a predetermined threshold as compared to its immediate neighbors, or if a neighboring Dell AP on another channel does not have any clients, load balancing will be enabled on that AP. This feature is disabled by default. Spectrum load balancing mode SLB Mode allows control over how to balance clients. Channel-based loadbalancing balances clients across channels. Radio-based load-balancing distributes clients across radios on the same band, independent of channels. Spectrum load balancing mode update interval This parameter specifies how often spectrum load balancing calculations are made (in seconds). The default value is 30 seconds. Spectrum load balancing threshold If the spectrum load balancing feature is enabled, this parameter controls the percentage difference between number of clients on a channel channel that triggers load balancing. The default value is 20%, meaning that spectrum load balancing is activated when there are 20% more clients on one channel than on another channel used by the AP radio. Advertised Regulatory Max EIRP Shows if the radio is configured to work around a known issue on Cisco 7921G telephones by capping for a radio's maximum equivalent isotropic radiated power (EIRP). When you enable this parameter, even if the regulatory approved maximum for a given channel is higher than this EIRP cap, the AP radio using this profile will advertise only this capped maximum EIRP in its radio beacons. The supported value is1-31 dBm. Spectrum load balancing domain Define a spectrum load balancing domain to manually create RF neighborhoods. Use this option to create RF neighborhood information for networks that have disabled Adaptive Radio Management (ARM) scanning and channel assignment. l If spectrum load balancing is enabled in a 802.11a radio profile but the spectrum load balancing domain is not defined, ArubaOS uses the ARM feature to calculate RF neighborhoods. Dell Networking W-Series ArubaOS 6.5.x | Reference Guide show rf dot11a-radio-profile | 1849