Dell W-Series 304 Instant 6.5.1.0-4.3.1.0 CLI Reference Guide - Page 726

Parameter mode-aware multi-band-scan no ota-updates ps-aware-scan rogue-ap-aware Description Range Higher power level settings may be constrained by local regulatory requirements and AP capabilities. If enabled, ARM will turn APs - into Air Monitors (AMs) if it detects higher coverage levels than necessary. This helps avoid higher levels of interference on the WLAN. Although this setting is disabled by default, you may want to enable this feature if your APs are deployed in close proximity (e.g. less than 60 feet apart). When enabled, single-radio - APs try to scan across bands for rogue AP detection. Negates any configured - parameter. The ota-updates option - allows an AP to get information about its RF environment from its neighbors, even the AP cannot scan. If this feature is enabled, when an AP on the network scans a foreign (non-home) channel, it sends other APs an Over-the-Air (OTA) update in an 802.11 management frame that contains information about the scanning AP's home channel, the current transmission EIRP value of its home channel, and one-hop neighbors seen by that AP. Default: enabled When enabled, the AP will - not scan if Power Save is active. When enabled, the AP will try - to contain off-channel rogue APs. Default l default: 9 dBm disabled enabled - enabled disabled disabled Dell Networking W-Series ArubaOS 6.5.x | Reference Guide rf arm-profile | 726