Dell W-Series 304 Instant 6.5.1.0-4.3.1.0 CLI Reference Guide - Page 1228

00 00 Interference Baseline FRR FRER --- ---- 17 4 Handoff Assist rssi-index cur-signal old-cur-signal 0 51 0 High Throughput Parameters ht-type primary-channel sec-channel gf-supported none 0 0 0 40mhz-intolerance 0 The output of this command includes the following information: Column retry Low-speed non-unicast recev-error frag bwth avg-signal Low-signal high-signal count Duration tx old-tx rx Description Percent of 802.11 retry frames sent because a client failed to send an ACK. Percent of frames sent at a data rate of 18 Mbps or slower. Percent of non-unicast frames Percent of error frames of all frames seen in the last second. Rate of fragmented packets, in frames per second Current bandwidth, in bps. Average signal-to-noise ratio over the interval since the AP's last reset. Lowest signal-to-noise ratio over the interval since the AP's last reset. Highest signal-to-noise ratio over the interval since the AP's last reset. Number of packets seen on the AP over the interval since the AP's last reset. Time over which the AP has measured RSSI values. The total number of deauthorization frames sent to this MAC address for containment in the interval from the AP's last reset until the current timer tick. The total number of deauthorization frames sent to this MAC address for containment until the previous timer tick. The total number of deauthorization frames spoofing the MAC address in the interval from the AP's last reset until the current timer tick. 1228| show ap monitor stats Dell Networking W-Series ArubaOS 6.5.x | Reference Guide