Dell W-Series 304 Instant 6.5.1.0-4.3.1.0 CLI Reference Guide - Page 184

Parameter clone eapol-rate-opt g-tx rates heartbeatthreshold hop-count link-threshold mesh-ht-ssid-profile max-retries mesh-mcast-opt Description Range Name of an existing mesh radio profile from which parameter values are copied. Default Use a more conservative rate for more reliable delivery of EAPOL frames. enabled disabled disabled Indicates the transmit rates for the 802.11b/g radio. The AP attempts to use the highest transmission rate to establish a mesh link. If a rate is unavailable, the AP goes through the list and uses the next highest rate. 1, 2, 5, 6, 9, 11, 12, 18, 24, 36, 48, 54 1, 2, 5, 6, 9, 11, 12, 18, 24, 36, 48, 54 Mbps Indicates the maximum number of 1-255 10 heartbeat messages that can be lost between neighboring mesh nodes. Indicates the maximum hop count from 1-32 8 the mesh portal. Indicates the minimal RSSI value. If the hardware 12 RSSI value is below this threshold, the link dependent may be considered a sub-threshold link. A sub-threshold link is a link whose average RSSI value falls below the configured threshold. If this occurs, the mesh node may try to find a better link on the same channel and cluster (only neighbors on the same channel are considered). The supported threshold is hardware dependent, with a practical range of 1090. High-throughput SSID Profile for the mesh feature. default Maximum number of times a mesh node can re-send a packet. 0-15 4 times Enables or disables scanning of all active stations currently associated to a mesh point to select the lowest transmission rate based on the slowest connected mesh child. When enabled, this setting dynamically adjusts the multicast rate to that of the slowest connected mesh child. Multicast frames are not sent if there are no mesh children. enabled 184| ap mesh-radio-profile Dell Networking W-Series ArubaOS 6.5.x | Reference Guide